No. Since Keylink Underfloor Heating Terminals provide single point control, it feed energy to all heating equipment. Thermostat and actuators will receive 230V supply from the card.
In system that doesn’t have terminals, the pumps continue to operate even if the heating stops. Through the Keylink Underfloor Heating Terminals software, the pump can be stopped. In this way, energy savings can be achieved. Unnecessary pressure build-up on closed actuators is prevented, the pump doesn’t have to flood the closed system and its life is extended.
Yes. Your heating needs are managed by the card with Keylink Underfloor Heating Terminals. Unnecessary operation of any equipment and unnecessary heating are prevented.
If there is a need for heating in a room, the pump runs. If all spaces are at the desired temperature, the pump stops working.
Yes. Maximum 6 thermostat can be connected. It is also usable for uses below this number.
15 actuators can be connected.
6 thermostats can be connected.
Keylink Smart Plus Underfloor Heating Terminals includes an under-screed temperature sensor in NTC type with IP67 protection class. This sensor measures the temperature of the water entering the collector and the terminal presents this value to the user on its digital display.
For safe operation/work, a ground terminal is attached to the card. With this, you can observe the working condition of the pump with the LED of the pump.
Yes.
No, card is delivered fixed to the bottom panel/tray. Since the terminals are clamped, the board does not need to be removed and reinstalled.
Keylink Underfloor Heating Terminals works compatible with all room thermostats.
The terminals at the upper part of the card are designed for thermostat connection. It is signified by thermostat symbols and T code.
Keylink Underfloor Heating Terminals are compatible with wall screw mounting. It will take its place next to the collector. The upper cover is separated from the lower plate and the cable connections are made with clamped terminals. The mounting is completed by screwing the covers together.
Keylink Underfloor Heating Terminals are designed with a LED that gives on/off information. This LED is directly connected to the 230V supply/feeding of the card and the on/off button. If there is energy on the card, this LED lights up red.
Yes. Since Keylink Underfloor Heating Terminals provide single point control, you can deactivate heating by the on/off button on it.
LEDs on the Keylink Underfloor Heating Terminals light up according to the information coming from the rooms in need of heating. If there is a need for heating in a room, the information coming from the thermostat in the room in question heats the room. In the meanwhile, the LED lights up. After the heating need is satisfied and the room temperature ends, the outgoing hot supply stops, and the LED turns off.
2 years.
You can inquire from which digital marketplaces you can buy Keylink Underfloor Heating Terminals from the Contact section of our website.
